All FAQs (1680 total: showing 1541-1560)
- If a computer does not have any serial ports, how can software (such as LoggerNet, PC400, PC200W, or Device Configuration Utility) talk to the data logger?
- Can external devices be switched on and off using a data logger?
- If a device or sensor is not available for selection in the Short Cut program, how can it be added?
- Can the data logger be damaged by wiring the sensors to the wrong ports?
- How can a floating point value be cast as a long integer?
- How can data that has been transmitted from a data logger to LoggerNet then be transmitted to a webhost that displays the data graphically?
- Is there a way to only record measurements during the daytime and put the data logger in sleep mode during the nighttime to conserve power?
- What is checked during the calibration of a Campbell Scientific data logger?
- Is it possible to use LoggerNet Admin software to connect to, and display data from, multiple data loggers?
- Can a data logger be contained in a waterproof enclosure?
- What does the PreserveVariables instruction do?
- Can more than one SDM device be connected to a data logger?
- Can Campbell Scientific data loggers be used with a telemetry system to remotely download data, check parameters, etc.?
- Can binary data be received via the serial terminal of a data logger?
- What might cause a CRBasic data logger to stop storing data?
- How can the amount of time before the memory of a data logger is filled be calculated?
- What are the rules regarding when data is deleted from a data logger?
- What is a USR drive?
- What needs to be done to get a CR3000 program to run on a CR9000 or CR9000X?
- If a CR3000, CR1000, CR800, or CR850 has TLS enabled and connects to a server whose certificate is not verified by a “trusted” signer, what will the data logger do?
Previous
Next