The ENC100 is a small 6.7 by 5.5 in. enclosure designed to hold a barometer. It includes a backplate, compression fitting, vent, and mounting bracket. It may also be compatible with other small sensors or peripherals.Read More
The ENC100 is typically used to house a barometer in its own enclosure. It includes a compression fitting for cable entry, a vent for equalization with the atmosphere, a backplate for mounting the barometer (or other small device), and hardware for mounting the ENC100 to a tripod, tower, or pole.
|Prepunched with one-inch-on-center holes
The ENC100 can house one small device (typically a barometer).
Number of FAQs related to ENC100: 3
Expand AllCollapse All
Either the CS100 or the CS106 can fit inside an ENC100. For more information, refer to the Specifications information on the ENC100 product page.
There is not an easy way to calculate how much desiccant is needed in an enclosure or how quickly the desiccant will need to be replaced. The following conditions affect the replacement interval:
It may be advantageous to use more than one desiccant packet at a time inside an enclosure. Campbell Scientific recommends keeping an extra supply of desiccant on hand for as-needed replacement in the enclosure.
The desiccant should be replaced when the top colored dot on the humidity indicator card (pn 28878) turns pink; the humidity indicator card is included in the enclosure supply kit that is shipped with each enclosure. If the CS210, Enclosure Humidity Sensor, is used, replace the desiccant when the measured humidity exceeds 35%.