The SnowVUE™10 is a digital, ultrasonic snow-depth sensor that provides continuous and accurate snow-depth measurements with its advanced spectrum analysis and best-in-class, wide-band transducer. With its low-power requirement and low-maintenance design, the SnowVUE 10 is suitable for most alpine and remote installations. The SnowVUE 10 also features Campbell Scientific’s total uptime diagnostic package to provide you with critical sensor performance measurements such as internal humidity, temperature, sensor level (tilt), measurement quality, and incoming voltage. An external air temperature sensor is required to correct for the changes in sound velocity due to changes in temperature.Read More
The SnowVUE™10 uses a wide-band, ultrasonic transducer to create sound pulses that are reflected off the snow surface. By measuring the two-way travel time of the pulse, the distance to the snow surface can be precisely calculated using advanced spectrum analysis. Because the speed of sound through air varies with the air temperature, an accurate air temperature measurement is required to correct for this change.
|Power Requirements||9 to 18 Vdc|
|Quiescent Current Consumption||< 300 µA|
|Active Current Consumption||
|Output||SDI-12 (version 1.4)|
|Measurement Range||0.4 to 10 m (1.3 to 32.8 ft)|
|Required Beam Angle Clearance||30°|
|Operating Temperature Range||-45° to +50°C|
|Sensor Body Material||Corrosion-resistant, type III anodized aluminum|
|Sensor Connector||M12, male, 4-pole, A-coded|
|Cable Type||Polyurethane sheathed, screened cable|
|Cable Diameter||4.8 mm (0.19 in.)|
|Maximum Cable Length||60 m (197 ft)|
|Sensor Length||9.9 cm (3.9 in.)|
|Sensor Weight||293 g (0.65 lb)|
Please note: The following shows notable compatibility information. It is not a comprehensive list of all compatible products.
The SnowVUE™10 is compatible with all current Campbell Scientific data loggers and retired data loggers that support the SDI-12 protocol.
Current SnowVUE10 operating system.
Note: OS update must be performed using the aXLOADOS! SDI-12 command. Please refer to the SnowVUE user manual for details on the update process.
Two programs that read the SnowVUE 10 sensor. One program performs temperature compensation to provide snow depth. The other program uses extended commands to send the air temperature and distance to ground to the sensor and the sensor calculates the snow depth. Both example programs are compatible with the GRANITE-series, CR6, and CR1000X dataloggers.