FAQs Frequently Asked Questions About our Products and Solutions

Ask a Question Ask a Question

All FAQs (1685 total: showing 1581-1600)

Does a CR5000 need a 4WPB100 to measure the internal RTD of a 4-way net radiometer?
Where are the holes in the CR3000 to attach it to the backplate of an enclosure?
If a CR3000 has some corroded terminal blocks, can those be replaced?
How is the VX voltage set in a CR3000?
What might cause a CR3000 to be unable to connect with DevConfig?
Is there a way to adjust the timeout on the LCD of the CR3000?
Can two CR3000s, located close to each other, be directly connected?
Does the CR3000 12 Vdc power terminal put out at least 6 mA?
How long does it take to recharge a rechargeable battery base for a CR3000?
How long will the rechargeable battery base of a CR3000 hold its charge?
If multiple CR3000s are linked together via COM1─COM4 ports and configured as neighbors on a PakBus network, what is the best way to synchronize the data loggers so that the time stamps match?
Can the CR3000 take input from, and supply power to, different types of sensors that require different voltages?
Other than using an Ethernet connection, is there any way to remotely download data from a CR3000 and adjust the program?
Can a CR3000 be run with a 12 V switchable power supply?
Is there any difference in the hardware between a standard temperature range CR3000 and an extended temperature range CR3000?
How many control terminals are available on the CR3000?
What is the common mode voltage for a CR3000?
Can the CS10-L be used to measure amperage from a battery?
Can the CS10-L be used in a three-phase power situation?
Are the CR800 and CR1000 capable of being programmed through a CD100 or CR1000KD without the use of computer software?

Previous Next