Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

NL100 reconfiguration


eastmanjoe Jan 2, 2019 12:28 PM

I have several older dataloggers (CR200X, CR800) using the NL100 interface setup to maintain PakBus TCP Client connections with our server.  We are in the process of moving our LoggerNet servers which is going to cause the IP address of our LoggerNet server to change.  The manual only shows how to change the settings via the RS232 port, but the device shows up in the PakBus graph.

I was wondering if we change the PakBus TCP Client setting in the NL100 remotely via the PakBus graph?

Log in or register to post/reply in the forum.