Hi,
I have a CR300 next to my office where I have few sensors like tipping bucket and a CS215. I want to put a radio RF422 on it to communicate to a CR1000 far from my office. I also want to use a NL240 with this CR300 to access all collected information from my desktop. Using the Network Planner it seems possible, one device in the RS-232 and the second one using a RS-232 through both control ports (C1 and C2). However, there is no room for a SDI-12 sensor.
Is there any way to connect all communication devices and my SDI-12 sensor or I need to change my datalogger to, at least, a CR300_RF422?
Thank you very much.
Best regards.
Borges
If you are going for a new logger, then you probably need a CR310-RF422 as the starting point, leaving all the serial ports and control ports free for sensors.
Thank you!
Best regards