Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

CR310 Digital input

Spol May 9, 2018 10:47 AM

Good ,day

according to the CR300 manual in the section "Digital Input/Output Specifications" I ca use the SE3/SE4 as digital input. I have a contact that when is closed power the SE3 with +12Vdc and I would like to get this high value state. How can I do it? With which command in the CRBasic?

Thank you very much

Paolo Saudin

Spol May 9, 2018 01:31 PM

I found it,

PortGet(VARIABLE, SE3), I was using the SE number instead of the code (PortGet(VARIABLE,3)) and it does not worked

Paolo

Log in or register to post/reply in the forum.