All FAQs (1778 total: showing 741-760)
- Can the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH be used in low-speed conditions, such as less than 5 cm/s? If so, what are the resolution and accuracy at these low speeds?
- What are the mounting options for the CSAT3?
- Is the offset relatively constant for a single CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH?
- How often does a CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH anemometer need to be recalibrated?
- Is there a way to determine the time at which the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH started reporting data with sub-second precision?
- How sensitive are the CSAT3A, CSAT3AH, CSAT3B, and CSAT3BH velocity measurements to sea spray in periods of high wind speed?
- Does the head of the CSAT3 need to be matched with its electronic box?
- Can the CSAT3B or CSAT3BH measurement frequency be changed? If so, what frequencies are supported by these sensors?
- Can the connectors for a PWENC enclosure be purchased separately?
- How easy is it to replace a defective component, such as a modem, from inside a prewired enclosure?
- What is needed to connect a modem to a data logger?
- Does the CM375 come with anchors?
- What if I don’t have a Campbell data logger for use with the CS725?
- Are there other things I should measure at the same site as SWE?
- What is the purpose of the CS725 collimator, and is it necessary?
- Are there any site conditions that may hinder the use of the CS725 sensor?
- Can the CS725 output in SDI-12 format?
- Is there a sample program for the CS725 available for my datalogger?
- What mounting hardware is required with the CS725?
- Can the CS725 sensor be installed once snow is on the ground?
Previous
Next