FAQs Frequently Asked Questions About our Products and Solutions

Ask a Question Ask a Question

All FAQs (1680 total: showing 461-480)

Can the A205 be used to determine whether a wireless sensor is a repeater in a wireless sensor network?
Can the A205 be used to determine signal strength (RSSI) of a wireless sensor?
To use the A205 with a wireless sensor interface and a wireless sensor base, is direct line of sight necessary?
What type of wind screen can be used for a tipping bucket rain gage?
If a phone line is shared with a seismograph that transmits data when it is called from a computer, is it possible to avoid interference by having the COM220 call out rather than transmit after receiving an outside call?
Why would installing a COM220 on a data logger disrupt the connection to a met station?
Can a COM220 be used to connect to a remote DCP using RS-232 through a cellular telephone?
Is there a way to remotely change the number of rings from two to four on the COM220?
What type of cable is compatible with the COM220 and can be used for a 2 km distance?
Can a COM220 and a spread-spectrum radio coexist on the CS I/O port of a PakBus data logger?
What is involved to install the COM220?
Is it possible to use a COM220 with a data logger to send text messages to a GSM phone?
Is it possible to make an SMS (short message service) with the COM220?
Can a COM220 be used to activate a solid-state power switch?
Can a VoIP (voice over Internet protocol) phone line be used to call a COM220?
What is needed to download data remotely using a COM220?
Are CS I/O communications possible with the COM220?
Other than by using the CRBasic Editor or Edlog, is there a way to remove the Default sensor and its measurements (for example, BattV, PTemp_C, and ProgSig) from SCWin?
What is Short Cut?
What is an easy way to program a data logger?

Previous Next