All FAQs (1680 total: showing 321-340)
- To use the CPEC200/310 scrub module as a source of zero gas, is it necessary for the CPEC200/310 system to include a valve module?
- Is there a calibration procedure for the PWS100?
- At a consistently windy site, is a PWS100 less accurate than a tipping bucket rain gage?
- How can a copy of the PWS100 Present Weather Viewing Software be obtained?
- What does the Present Weather Viewing Software do? For example, can it save data?
- Can a PWS100 be used to measure visibility? If so, can it be used in a sandy area such as the Sahara Desert?
- What is the current drain of the PWS100?
- How is the PWS100 different from a rain gage or snow depth sensor?
- Can an HFP01SC provide correct running averages if the scan rate is reduced to 1 minute?
- If Short Cut does not list the TCAV on its sensor list, what should be done?
- Is it OK to have a TCAV connected to a data logger using a very long cable (100 ft/30 m)?
- What are the measuring range, accuracy, and resolution of the TCAV?
- What might cause a 25% difference between the factory calibration and the in-situ calibration of an HFP01SC?
- What type of quality assurance/quality control can be performed on HFP01SC measurements?
- For the HFP01SC, is there an available acquisition program that is capable of running in PipeLineMode?
- If Short Cut does not list a heat flux plate on its sensor list, what should be done?
- Does the HFP01SC have to be in direct thermal contact with the surrounding soil to achieve heat flux readings?
- Can the HFP01SC be embedded in railroad ballast, which comprises a blend of coarse rock particles?
- If the heat flow from the inside of a wall to the outside of a wall is being measured on the outside, should the blue face or the red face of the HFP01 touch the wall?
- If the cable of the HFP01 gets cut, can the cable be soldered to have the sensor work normally?
Previous
Next