FAQs Frequently Asked Questions About our Products and Solutions

Ask a Question Ask a Question

All FAQs (1680 total: showing 1321-1340)

What should be done if Short Cut does not list the CC5MPX as a device that can be added?
How can images from a CC5MPX be downloaded directly through the Ethernet port using a remote script rather than using a browser or LoggerNet?
What are possible causes for the message “Classic::CmdClockSet”?
How is communication achieved through a data logger CS I/O port?
What is the difference between the SC32A and the SC32B?
Is an SC32B needed to communicate between a data logger and a PC?
Should an SC32B be installed between the RS-232 port on a data logger and the port on a desktop PC to prevent ground loop issues?
Can the SC32B be used with an SDC device?
Why is it important for the SC32B to be optically isolated?
What is needed to set up a communication network for an eddy-covariance system in a remote location?
Can an ENC16/18 be used with an enclosure heater to increase the inside temperature and reduce the risk of condensation?
Can converters to 18 Vac and 12 Vdc be located within an ENC16/18 without affecting the data logger or data?
Can 120 Vac be brought into the ENC16/18?
How many mounting accessories should be ordered for each major device inside an enclosure?
Is a fiberglass enclosure suitable for an installation in a very cold location monitoring corrosion?
If the copper ground terminals attached to the bottom of an enclosure are oxidized and corroded, how can they be replaced?
What are the distances, center-to-center, of the mounting holes in the back of the ENC14/16?
If the PVC fittings at the bottom of the enclosure have too small an inner diameter to accommodate all the cables passing through, is there a way to remove the PVC fittings?
What is the preferred method for punching a clean hole through the bottom of an enclosure?
Can just the backplate of an enclosure be purchased?

Previous Next