Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Control RV50 with a control Port (5 Vdc)

GRM May 4, 2017 03:42 PM

Hello,

The manual of the RV50 (from Campbell) states that is possible to control power to the RV50 using 12V, SW12 or a control port connected to the white cable, i want to confirm if is possibe to control power to the RV50 with a control port connected to the white cable (5 volt output) of course 12 volt connected to red wire and G connected to black wire

Thank you

JDavis May 4, 2017 08:36 PM

Yes, as stated in the manual, the 5V from a control port is enough to switch the modem on.

GRM May 4, 2017 10:39 PM

Thanks!! Great i need the SW12 for other sensors

Regards

Log in or register to post/reply in the forum.